Lee Challenger with Uniflow

[Boats]

Originally Posted by DaFadda

Pitlog, below is my uniflow in a dedicated stand. For the life of me, I can't figger out why you're using the Lee single stage to hold the uniflow for charging cases. The way this is set up, you'll have to handle each and every round for the charging process.

I think the additional stand is about 20 bucks on Ebay and allows me to batch load a fifty count loading tray at one time. I think I'd go nuts if I had to handle each round to charge. Here's a couple of pictures of what I'm talking about. Hope this helps...

Da

Thanks, . I'm not too sure how to answer except to plead ignorance.

So what do you do, load up a tray with primed brass and then use a funnel under the Uniflow? I'm trying to figure out what you do if you are not touching the cases.

There was a stand up for bid on ebay, but for just a hair more I found it on Midway and bought one.

Thanks for the reply. This is my first experience with a single stage press and also with the Uniflow. Up till now, everything has been done by hand and on a Classic Turret Press.

Tom